Mounting The First Side Extension Leaf; Mounting The Slide Rail Assembly - Axminster 200387 User Manual

THE EXTENSION LEAF IS HEAVY YOU MAY REQUIRE
!
A SECOND PERSON TO HELP LIFT IT IN PLACE
Select one of the extension leaves, (either one, they are identical) locate 4 No. M8 hexhead
bolts and washers. Ensure the table is correctly orientated (the front edge of the table is
bevelled). Stand the back end of the table on the floor, close to the front and edge of the
main saw table, with the underside of the table facing the front of the saw. Lift the table up
and introduce a washered bolt through the first hole in the leaf and screw it into the first
threaded hole along the main table edge.
Screw the bolt in until it is almost home. You can now relax the lifting effort. The extension
will hang pivoted on the bolt. Carefully lift the bottom end of the extension up until the
edges are level and introduce a washered bolt through the rear hole and the last threaded
hole in the table edge, screw it almost home. The extension should be hanging in
approximately its correctly position held by the two bolts. Introduce and almost screw home
the other two washered bolts. Align the top and front edges at the front of the saw, 'nip' the
front bolt to hold the extension in place; carefully manoeuvre the rear of the extension to
align the two top edges and 'nip' the rear bolt. Check this movement has not disturbed the
alignment at the front of the table, if it has, repeat the procedure until the front and top
edges are aligned. Tightened all the bolts securely.
Side rail assembly
Locate and identify the mounting brackets and the height adjustor blocks. (See figs 10 & 11)
These are mounted on the outside faces of the upper chassis legs. They are anchored
against clamping plates that are behind the face of the legs.
NOTE: These clamping plates are 'loose items', each is initially held in place by three
pre-introduced fixing bolts. It is suggested that you do not remove all these bolts at the
same time. The suggested procedure is:- unscrew the caphead bolt in the height adjustor
block until the recessed hole for the fixing bolt is clear, remove the lowest bolt; fit it through
the height adjustor block and screw it back into its position. Screw it almost home. Remove
the top bolt, fit it through the top hole of the bracket, and with the bracket tilted to one side,
screw it back into its position.

Mounting the First Side Extension Leaf...

Mounting the Slide Rail Assembly...

Fig 10
Mounting
Cuphead
FREEPHONE
bracket
Height
adjustor
block
bolt
unscrew the caphead bolt in the height
adjustor block until the recessed
hole for the fixing bolt is clear
0800 371822
W
A X M I N S T E R
W H I T E
Fig 11
13