Assembling the Rear Extension Table...
W
A X M I N S T E R
W H I T E
Remove the 6 fixing bolts in each of the two top, side panels, put carefully aside and
remove the panels. (See figs 6 & 7) This gives easier access to the back of the two rear
upper chassis legs. Locate the rear extension table brackets, the clamping straps and 4 No.
M8 caphead bolts and washers.
PLEASE NOTE: the manufacturer has fitted adjusting bolts to the brackets, these are the
faces that back against the legs.
Offer the clamping plates up to the inside face of the legs, fasten the bracket using
washered bolts through the bracket and the leg into the clamping strap. Tighten the bolts
finger tight only at this time. (See figs 7,8). Locate the table and the other 4 No. M8
caphead bolts and washers. Mount the table onto the brackets,
Note: that the securing bolts need to feed through the elongated holes in the bracket. (the
extension table is spaced off the main table to allow clearance for the rear clamping rail and
the rip fence). Leave all bolts finger tight at this time.
Fig 6
Inside face of the leg
Fig 8
12
Side panels removed
M8 caphead bolts
and washers
www.axminster.co.uk
Table fixing
holes
Mount the table onto the brackets
Fig 7
Table bracket
Fig 9