Setting The Sliding Table - Axminster 200387 User Manual

Fig 15
Fig 16
Set the sliding table so that the front edge is inline with the front edge of the saw table.
Place a long straight edge (a bit more than twice the width of the sliding table) along the
front edges of the two tables. Set the near corner of the table to the straight edge.
Move the table and the straight edge to the rear of the MAIN table. Set the rear corner to the
straight edge. Adjust the table to bring it level under the straight edge. Move the table and
the straight edge back to the front of the main table and check the table is level; adjust if
necessary. Once you are satisfied, and all the bolts are now 'nipped', slide the table back
and forth and check the gap between the sliding table and the main table.
It should be approximately 2-3mm and uniform alongside the main table. Adjust as
necessary, making uniform adjustments of the bolts in each bracket. Again, when you are
satisfied; 'jack' the table up by screwing both the height adjusting bolts UP approximately
3/ 4
turn. This will raise the table by something less than a millimetre and will reduce the
drag of the workpiece at the main table edge, giving easier, more controllable movement.
Check all bolts are tightened up, recheck all your settings.......etc. etc.

Setting the Sliding Table...

FREEPHONE
0800 371822
W
A X M I N S T E R
W H I T E
17