Master/Slave Fixture Linking; Orientation; Operating Instructions; Navigating The Control Panel - Varytec Easy Move XS HP Wash User Manual

4.4. Master/Slave fixture linking

1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3pin
connector of the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector.
Then, proceed to connect from the output as stated above to the input of the following fixture
and so on.

4.5. Orientation

This fixture may be mounted in any position provided there is adequate room for ventilation.

5. Operating instructions

5.1. Navigating the control panel

Access control panel functions using the four panel buttons located directly under the Display.

5.2. Menu map

Six distinct operating modes, many with sub-modes, are supported by the unit. To selected use the
"MODE/ESC" button to enter the menu. "UP" and "DOWN" button choose from values available with
the "ENTER" button confirming any selection. After a few seconds, the LED Display will back during
operation until another button is pressed.
In –built Program Mode

User configurations

5.3.

5.3.1. Setting Maximum Pan Angles

To select, use the "MODE/ESC" button and choose "PA18", "PA36",or "PA54". "UP" and "DOWN"
buttons cycle between all available Pan Angles. Press the "ENTER" button to confirm the chosen
selection.
LED Display
PA18
PA36
PA54

5.3.2. Setting Maximum Tilt Angles

To select, use the "MODE/ESC" button and choose "t.9" or "t.18" "UP" and "DOWN" buttons cycle
between all available Tilt Angles. Press the "ENTER" button to confirm the chosen selection.
LED Display
t.9
t.18
Maximum Pan
180º
360º
540º
Maximum Pan
90º
180º
8 / 14