Advertisement
2. Product description
LED Lightsource: 2x 9W LED, RGB 3in1,
Master Slave Mode
Sound Control Mode
Volt: AC240V 50 Hz
Powerconsumption: max 35W
Working temperatur: Indoor 0°C- +40°C
Wight: 5 kg
Size: 450L x 450B x 230H
Use: for Nightclubs, Entertainment Areas or Disco
Description
: This Product uses extrem bright LEDs as lightsource. These are bright, well coloured,
hitproof, and they have a extreme long lifetime up to 100 000 h . Further advantages are less heat and
less powerconsumption. Instead of other products this one is able to work 24 hours without breaks.
3. Installation
1. You can mount this product in every position , make sure that there is a distance of min 1 m to
walls or flammable stuff. Be sure to mount he product well and don´t forget the ground.
2. Make sure to have the wright voltage and power..
3. Attention : the XLR connector is no DMX connector, never use DMX products or
controller in the line!!
4. Start Up
1. Connect the product to the powersource, now you are in music mode.
2. now the product reacts to music impuls.
3. with the potentiometer on the back you can controll the sensitivity of the mikrophon.
4. if there is no music signal for about 10 sec. it shuts down the motor and lightsource.
5. Master Slave Mode
1. Choice the product which you want to bot he master.
2. choice the desired sensitivity on the master.
3. connect all slave products in the lin with XLR plug.
4. every seitivity of the slave products have to be 0.
5. Now every slave reacts like the master do.
6. Attention : the XLR connector is no DMX connector, never use DMX products or
controller in the line!!
4 / 5
Advertisement
