Features; Powerconnection; Working Modes; Music Control Mode - Varytec LED Spot 3 User Manual

Important:

Damages caused by the disregard of this user manual are not subject to

warranty. The dealer will not accept liability for any resulting defects or

problems. Make sure the electrical connection is carried out by qualified

personnel. All electrical and mechanical connections have to be carried out

according to the European safety standards.

2. Features

Multicolour

Electronic dimming device 0 – 100%

Built in microphone

DMX 512 Protocol

3 or 5 DMX Channels

Before connecting this item to the mains make sure that the local power connection is fitting to this

LED Spot 3! The LED Spot 3 needs 100V ~ 230V AC.

In this mode the LED Spot 3 react to music and plays the different colors.

1. Power on the item and set the Dip switch #10 to ON

2. Now the item changes the color according to the music.

3.2. Master Slave mode

With this function you can connect up to 16 fixtures and use them without a controller. The items work

in a music control mode. In this mode one item works as control unit and the ithers reacting according

to it and its preprogrammed programs. Each item can be defined to be a master or a slave.

1. Daisy chain the items with DMX Cables using the backside XLR Connectors.note that the

male connector is the IN and the female connector is the out at the item. The first item in the

row uses the female connector only and the last item in line should use the male connector

only. If the cable are longer then you should use a terminator at the end of the line.

2. At the master item you should set up the dip switches 1-9 to OFF

3. At the slave unit please set all dip switches to ON

4. Now the slave items follow the master and its programs.

With this function you can set up a 4-light show from the master or from a slave item. Please do

step 1 from setting up a master slave mode and then go a s described here:

4 / 6

Table of Contents