Oki PACEMARK 4410 Service Manual page 89

Item No. Items
1 Protector Gap Adjustment
(1)Range Adjustment
1
O N - L I N E
POWER
F R O N T F E E D
2
ALARM
3
ONLINE
GROUP
RESET
2
1
(2)Protector Gap
Protector Frame
40496501TH Draft Version
Standard Value
Rear Cover (B)
7
E P S
5
MENU CONFIG
6
STORE
SHIFT
ITEM OPTION
3 4
8
Gap Measuring Points
Platen
Ribbon Guide Post
Illustration
1Remove the Rear Cover (B), and set
Dip Switch 1 on the board to "ON"
DIP Switch
(maintenance mode).
Lower Cover
FF/LOAD
LF
PATH
TEAR
MicroFeed MicroFeed
TOF
Up Down
9 0 A B
2Close the access cover, and turn on
the printer while pressing Switches 7
and 10 on the operation panel. (This
starts the auto gap adjusting mode.)
The platen moves forward/ backward
up to the adjusted position.
3When the platen stops, turn off the
printer.
1Insert the thickness gauge between
the platen and the protector frame to
verify the protector gap value B is bet-
ween 0.12 and 0.16 mm.
Notes:
Although the adjustment should use a
range from 0.12 to 0.16mm, the configura-
tion should use a range from 0.09 to 0.2mm
2If adjustment is required, screw down
the ribbon guide post with the Philips
screwdriver and adjust the protector
frame to make the protector gap value
B between 0.12 and 0.16 mm, then fix
the protector frame.
Notes:
a) The protector frame should be
mounted parallel with the platen, when
measured at the right/left gap measur-
ing points.
Adjustment Method
Temporary
ON
OFF
1 2 3 4
Maintenance
ON
OFF
1 2 3 4
DIP SW
PARK
C
88