Reset Function; Set System Date; Setting The System Clock - Interlogix NetworX NX-6V2 User Manual

zone(s) will be displayed on the LCD keypad.
entered into alarm memory and the internal log.
Step 3 The keypad will begin to beep after 15 minutes in this mode. This
beeping indicates that the "Walk-Test" mode will be automatically
exited in 5 minutes.
Step 4 To exit at any time during this mode, enter a user code. Otherwise
the AWalk-Test Mode@ will automatically exit after 20 minutes.

RESET FUNCTION

This function is used to reset Smoke Detectors, Zone Troubles, and Zone
Tampers.
Step 1 Disarm the system if not disarmed.
Step 2 Press [ ]-[7]. Resets have now been performed.
Step 3 If the keypad begins beeping, the reset did not execute properly.
Enter your code to silence the keypad. Wait a few minutes and
repeat step 2 to attempt another reset. If the keypad still beeps after
repeated attempts, please contact your installer.

SET SYSTEM DATE

Step 1 Press the [ ]-[9]-[6].
Enter the "Master Code".
Step 2
Enter the "Day of Week "
Step 3
1 = Sunday
2 = Monday
Enter the "Month Code". Must always be two (2) digits.
Step 4
01 = January
02 = February
03 = March
04 = April
Enter the "Day Code". Must always be two (2) digits.
Step 5
Example: The 5
Enter the last two digits of the "Year Code".
Step 6
Example: For 2007 enter [0]–[7].

SETTING THE SYSTEM CLOCK

Step 1 Press [ ]-[9]-[7].
Enter the "Master Code ".
Step 2
Enter the "hour code" which must be two (2) digits. Note: The
Step 3
clock is a 24-hour clock. Refer to the following table on page 14.
Enter the "minutes code" which must be two (2) digits.
Step 4
Example: 7 minutes after would be entered [0]–[7].
3 = Tuesday
4 = Wednesday
05 = May
06 = June
07 = July
08 = August
th
would be entered as [0]–[5].
13
5 = Thursday
6 = Friday
09 = September
10 = October
11 = November
12 = December
It will also be
7 = Saturday