Convection Blower; Combustion Blower; Vacuum Switch; Vacuum Switch Port - England's Stove Works 25-PDV Installation & Operation Manual

Hide thumbs Also See for 25-PDV:

Installation and operation manual (26 pages)

Table Of Contents

Table of Contents

Available languages

The Convection (room air) Blower (Part # PU-4C447) is located on the left side of the unit and can

be removed by disconnecting the power leads and removing the four mounting screws. Once this is

done, the blower will slide out of the stove. This procedure can be reversed to install a new blower.

To replace the Combustion (exhaust) Blower (Part #PU-076002B), the power leads and the pellet

vent pipe must be disconnected. Next, remove the screws that hold the blower to the steel exhaust

tube and slide the blower from the stove. Note: There is a Combustion Motor Gasket (Part PU-

CMG), which allows you to remove the motor from the Combustion Blower housing, clean your stove,

and replace the motor and gasket without having to remove the entire Combustion Blower. If cleaning

your blower, the blower impeller, blower tube and steel blower exhaust tube on the unit should be

brushed and vacuumed. However, if you must remove or replace the entire Combustion Blower, a

new blower flange gasket (Part # PU-CBG) should be added between the blower flange and the steel

exhaust tube.

This unit is equipped with Vacuum Shut Down Switches (Part # PU-VS and CU-VS), which help

control various functions of the unit. If an operational error occurs in the unit, a switch will either stop

the top (feed) auger or shut the unit off; if the unit turns off an E-1 Code (error code) will appear in the

Heat Range and Blower Speed windows of the Control Board. Situations which could cause this

include power failure, Combustion Blower failure, improper flue installation, a blocked flue (from

rodents, nests, etc.), or "dirty burning" from burning improper fuel (see "Important Information" at the

beginning of the manual).

If necessary, remove right side louver

to determine where vacuum port enters

firebox

NOTE: The "door ajar" vacuum switch port must be kept clean, or the top auger will cease to function.

Locate the port hole on the right wall of the burn chamber (you may remove the right louver to follow the

vacuum tube to locate the hole) and, with the stove unplugged and cooled down, use a brush or pipe

cleaner (not a vacuum) to keep this port clear of ash or other debris (see picture).

IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING

CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.

ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR

DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.