Parts List - England's Stove Works 25-PDV Installation & Operation Manual

REPLACEMENT PARTS, ACCESSORIES AND OPTIONS
AC-GGK
AC-DGKC
AC-114
AC-114BN
AC-G9
AC-SH
AC-SHN
AC-MBSP
PU-AMS
PU-047040
PU-BP02A
PU-076002B
PU-4C447
PU-AF6T
PU-AF11B
PU-62-40-151-3
PU-UCF204-12
PU-2X570
PU-CB04
PU-VS
CU-VS
PU-CBG
PU-CMG
PU-BPG
PU-ABGN
PU-HLG
PU-CHA
PU-CBF6
AC-HLSB
AC-HP
PU-OAK
AC-3000
AC-3100
PU-DTSTAT
AC-103
AC-103BN
AC-106-P
AC-106-PBN
If you have any questions or problems contact the Technical Support Department:
Technical Support Department
P.O. Box 206
Monroe, VA 24574
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.
Glass Gasket Kit (gasket only, no glass)
Door Gasket Kit (#2 on diagram)
Brass Louvers (#26 on diagram) (2001 and later Models; for earlier models
call 800-245-6489 for AC-112 louvers)
Nickel Louvers (#26 on diagram)
9" x 9" Glass with Gasket (#3 on diagram)
Brass Door Spring Handle
Nickel Door Spring Handle
Hi-Temperature Black Paint
Auger Motor Support Gasket
1 RPM Auger Motor Assembly (#18 on diagram)
Burn Pot Assembly (#'s 5 and 11 on diagram) (2002 and later Models; for
earlier models order PU-BP96)
Combustion (Exhaust) Blower (includes 3" adapter; #'s 8 and 9 on diagram)
Convection (Room Air) Blower (#13 on diagram) (2002 and later Models; for
earlier models order PU-4C442)
Top Auger Shaft (#14 on diagram)
Bottom Auger Shaft (#14 on diagram) (2001 and later Models; for earlier
models call for assistance)
Hopper Lid Latch (2002 and later Models;
for earlier models order PU-103-50) (#25 on diagram)
Auger Bearing (#16 on diagram)
¾" Locking Collar (#17 on diagram)
Digital Control Board (#12 on diagram)
Vacuum Shut-Down Switch (see Control Board diagram)
Second Vacuum Switch (see Control Board diagram)
Combustion Blower Gasket (#10 on diagram)
Combustion Motor Gasket
Burn Pot Gasket (#6 on diagram)
Auger Bearing Gasket (#15 on diagram)
Hopper Lid Gasket (#22 on diagram)
Cartridge Heater (Igniter) Assembly (#27 on diagram)
6 AMP Control Board Fuse
Hopper Lid Safety Switch (See wiring diagram pg. 19, 09/2008 & later only)
Hinge Pin rivet for cast door (not shown)
OPTIONS:
Outside Air Kit
3" Pellet Vent Kit (Through-the-Wall)
4" Pellet Vent Kit (For High Altitudes – 4000+ ft.)
Wall Thermostat
Brass Lip Trim for Ash Apron (2001 and later Models;
for earlier models, order part # AC-101-PU.)
Brushed Nickel Lip Trim for Ash Apron
Brass Window Trim
Brushed Nickel Window Trim
service@englanderstoves.com
Parts Orders ONLY: 800-516-3636
Questions: 800-245-6489
25
(Fax: 434-929-4810)