Exhaust Blower; Convection Blower - England's Stove Works Imperial Installation & Operation Manual

Exhaust Blower Cleaning
Although the exhaust blower and blower housing were designed to minimize ash build‐up, some fly‐
ash will still accumulate there throughout the burning season. The amount and type of ash will depend
on the type of pellets and venting system, but generally this accumulation will be mild. If, when
cleaning the exhaust blower, a large accumulation of fly‐ash is found, cleaning the exhaust blower and
housing should be performed monthly or bimonthly to prevent this excess buildup.
Instructions
 Before beginning the exhaust blower cleaning procedure, be certain the unit is unplugged and
thoroughly cooled down.
 Remove the panel to the left (if facing the stove). See page 43 for panel removal instructions.
 Once the panel is off, the exhaust blower will be clearly visible.
 Disconnect the venting system from the exhaust blower just enough that you will be able to
remove the exhaust blower from the stove (the rear panel will also need to be removed).
 Unplug the two wires which connect the stove wiring harness to the exhaust blower, using the
quick connect plugs.
 Loosen the five (5)
blower tube; a 12" socket extension will likely be necessary to reach all of the screws.
 Lift the exhaust blower up and out of the stove. The gasket which seals the exhaust blower to
the exhaust blower tube is fragile, so take extra care when removing the blower. Even when
being careful, though, it is easy to tear this fragile gasket, and since an airtight seal is crucial
here, it is best to replace this gasket (Part # ‐ PU‐CBG) every time the exhaust blower is
removed.
 With the exhaust blower removed, use a utility vacuum to remove any ash accumulation in the
exhaust blower tube.
 Use a soft paint brush and carefully remove any ash accumulation from the inside of the
exhaust blower, and from the exhaust blower fan blade.
 Inspect the exhaust blower motor for dust accumulation and carefully remove it, ensuring that
all air cooling holes into the motor are open and free of dust deposits.
 Install the blower in the reverse order as described above. Remember to check the condition of
the exhaust blower gasket.
 Reinstall the venting system and panels.
Convection Blower Cleaning
As always, be certain the stove is cool and unplugged before servicing any components within the unit.
Since the convection blower does not handle any by‐products of combustion, it does not require serious
cleaning like the exhaust blower. However, dust from the home and other debris in the air can accumulate on
the blades of the convection blower. The convection blower is located on the side of the stove opposite the
combustion blower, and an access panel on the stove is provided, for easy convection blower cleaning. Any
dust that has built up on the fan blades can usually be easily removed with a vacuum or a soft paint brush.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING
THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT,
OR DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY

YEARLY MAINTENANCE
5
/ " self‐drilling screws which hold the exhaust blower to the exhaust
16
QUESTIONS.
30