Table of Contents
Advertisement
Chapter 5 Remote Interface Reference
RS-232 Interface Configuration
RS-232 Interface Configuration
See also "Remote Interface Configuration" in chapter 4 on page 150.
This section contains information to help you use the instrument over
the RS-232 interface. The programming commands for RS-232 are listed
on page 269.
RS-232 Configuration Overview
Configure the RS-232 interface using the parameters shown below.
Use the front-panel Interface menu to select the baud rate, parity,
number of data bits, and flow control mode (see page 152 for more
information).
Baud Rate: 1200, 2400, 4800, 9600, 19200, 38400,
57600
(factory setting), 115200
Parity and Data Bits: None / 8 data bits (factory setting)
Flow Control:
Number of Start Bits: 1 bit (fixed)
Number of Stop Bits:
270
Even / 7 data bits
Odd / 7 data bits
None (no flow control)
XON/XOFF
(factory setting)
DTR/DSR
RTS/CTS
Modem
1 bit
(fixed)
Advertisement
Table of Contents
