Table of Contents
Advertisement
Chapter 1 Quick Start
To Prepare the Instrument for Use
To Prepare the Instrument for Use
1 Check the list of supplied items.
Verify that you have received the following items with your instrument.
If anything is missing, contact your nearest Hewlett-Packard Sales Office.
One power cord.
This User's Guide.
One Service Guide.
One Quick Reference Guide.
Certificate of Calibration (if you ordered the internal DMM ).
Quick Start Package (if you ordered the internal DMM ):
Any plug-in modules that you ordered are delivered in a separate
shipping container.
On/Standby
2 Connect the power cord and turn on the instrument.
Switch
WARNING
The front-panel display will light up briefly while the instrument
Note that this switch
performs its power-on self-test. The HP-IB address is also displayed.
is
Standby
only.
The instrument initially powers up with all measurement channels
To disconnect the
turned off. To review the power-on display with all annunciators
mains from the
instrument, remove
turned on, hold down
the power cord.
instrument does not turn on properly, see page 27.
3 Perform a complete self-test.
The complete self-test performs a more extensive set of tests than those
performed at power-on. Hold down
and hold down the key until you hear a long beep. The self-test will begin
when you release the key following the beep.
If the self-test fails, see the HP 34970A Service Guide for instructions on
returning the instrument to Hewlett-Packard for service.
One RS-232 cable.
HP BenchLink Data Logger Software CD-ROM.
To install the software, see page 18.
One J-type thermocouple and a flatblade screwdriver.
as you turn on the instrument. If the
as you turn on the instrument
1
17
Advertisement
Table of Contents
