Table of Contents
Advertisement
Chapter 4 Features and Functions
Remote Interface Configuration
Remote Interface Selection
The instrument is shipped with both an HP-IB ( IEEE -488) interface
and an RS -232 interface. Only one interface can be enabled at a time.
The HP-IB interface is selected when the instrument is shipped from
the factory.
The interface selection is stored in non-volatile memory, and does not
change when power has been off, after a Factory Reset (*RST command),
or after an Instrument Preset (SYSTem:PRESet command).
If you select the HP-IB interface, you must select a unique address for
the instrument. The HP-IB address is displayed on the front panel
when you turn on the instrument.
If you select the RS -232 interface, you must also set the baud rate,
parity, and flow control mode for the instrument. " RS -232" is
displayed on the front panel when you turn on the instrument.
Front-Panel Operation:
HPIB / 488 , RS-232
Remote Interface Operation:
SYSTem:INTerface {GPIB|RS232}
4
151
Advertisement
Table of Contents
