Dial Mode; Setting Time And Date - AT&T 924 User Manual

924 book_1ATT 8/8/00
INSTALLATION

Dial Mode

This telephone will work with touch tone or dial pulse (rotary) service.
Each line comes set in the tone (tt) mode. Make sure you choose the
correct dialing method (DP or tt) for each telephone line; touch tone
dialing will not work if you have dial pulse service.
Press U.
1
2
Select the line.
Press #.
3
Press 3 to change the dial mode to DP (dial pulse)
4
— OR —
Press 8 to change the dial mode to tt (tone).
Press U to exit
5
— OR —
Press a LINE button to set the dial mode for that line.
Even when set to dial pulse (DP), the phone can be switched temporarily
to tone for access to services that require tone signaling, including some
tone-activated computer systems. To switch from pulse to tone dialing
during a phone call, see "Temporary Tone Dialing" in TELEPHONE
OPERATION.

Setting Time and Date

The screen displays the time and date when the phone is not in use and
the ringers are on.
Press C.
1
2
Use the dial pad to enter the correct time. For example, press
1 5 3 to set the time to 1:53.
Press * for AM or # for PM.
3
Enter the correct date. For example, press 9 0 1 to set the date
4
to September 1.
Press C again.
5
To Reset Time Only
Follow Steps 1–3 above, then press C.
To Reset Date Only
Follow Steps 1, 3, 4, and 5 above (skip Step 2).
10
11:24 AM Page 10