AT&T 924 User Manual page 7

924 book_1ATT 8/8/00
5 Connect the power adapter.
Fit the power cord behind the strain relief tab. Then plug the
smaller end into the power jack on the back of the system.
Plug the power cord into an electrical outlet that is not controlled
by a wall switch.
NOTE: The power adapter connects the same way whether you
use four one-line jacks or two two-line jacks.
6 Check for dial tone.
Press L, lift the handset, and listen for dial tone. Repeat for
Lines 2, 3, and 4. If you cannot hear a dial tone, see IN CASE OF
DIFFICULTY.
7 Confirm Lines 1, 2, 3, and 4.
Make sure none of the lines is in use. Press L and call one of
your telephone numbers. If you hear a busy signal, L is the
number you called. If another line rings, it is the number you
called. Repeat Step 7 to check all other connected lines.
11:24 AM Page 5
Use only the power adapter provided with this product. To
obtain a replacement, call 1 800 222-3111.
INSTALLATION
Strain-relief tab
Power cord
5