Table of Contents
Advertisement
Configuration utilities
Configuration utilities
If the command line [-on | -off | -check] options are used,
xsecure does not use the GUI interface. These options allow the user to
turn the secure mode on, off or allow the user to check the secure mode
status.
A simple button with a red or green secure mode indicator provides the
user with secure mode status information. The red indicator shows that
the secure mode process has begun. The label near the red button will
inform the user when the SSP is secure. A green indicator and the
appropriate label shows that the network is available and the SSP may
be accessed through the ethernet port.
In order for xsecure to work properly the SSP, console cables, terminal
mux and modems must be configured in specific ways. The SSP JTAG
connections, OBP connections and an optional terminal mux must all be
connected to the Diagnostic LAN and identified in the /etc/hosts file
as tsdart-d. The sppconsole serial cable must be connected to serial
port 1 and to node 0. An optional modem may be connected to serial port
2.
116
Chapter 5
Advertisement
Table of Contents
