Reset The Node; Figure 37 Ts_Config Scub_Ip Address Configuration Confirmation; Figure 38 Ts_Config Scub_Ip Address Set Confirmation Panel - HP 9000 V2500 SCA Operator's Manual

Figure 37
Step 4. A panel as the shown in Figure 38 appears confirming that the scub_ip
Figure 38
Step 1. Select the desired node from the list of available nodes.
Step 2. Select "Actions," then "Reset Node." This is indicated in Figure 39.
Configuration utilities
ts_config
ts_config scub_ip address configuration confirmation
address is set. Click OK.
ts_config scub_ip address set confirmation panel
Initiate a node reset to activate the new scub_ip address.

Reset the Node

82 Chapter 5