Step 1. Select the desired node from the list of available nodes.
Step 2. Select "Actions," then "Deconfigure Node," then click "Yes."
Step 1. In the ts_config display, select "Actions," then "Configure Terminal
Figure 41
Step 2. Connect a serial cable from serial port 2 on the SSP to port 1 on the
Step 3. A panel shown in Figure 42 display the IP address.
Configuration utilities
ts_config
Deconfigure a Node
Deconfiguring a node removes the selected node from the SSP
configuration. The SSP will no longer monitor the environmental and
hard-error status of this node. Console access to the node is also be
disabled.
Add/Configure the Terminal Mux
To add or reconfigure the terminal mux, perform the following procedure.
Mux."
Select "Add/Configure Terminal Mux." This is indicated in Figure 41.
ts_config "Add/Configure Terminal Mux" selection
terminal mux.
84
Chapter 5