Table of Contents
Advertisement
Maintenance
8.
Each lever is attached to the scanner chassis with a small hook that rests on a round pin. As you hold
the glass-plate on both its edges, lift it upwards to detach both lever's hooks from the pins and thus
free the glass-plate from the scanner.
Reverse the above operations to reinsert a new glass-plate – Fit the new glass-plate's lever hooks on
9.
to the pins on each side of the scanner.
10. While supporting the glass-plate with fingers on the lever handles, carefully let the glass-plate down
backwards (away from your body) and ease it into place.
11. Close the scan area lid.
NOTE: Make sure you clean a new glass-plate before using it with the scanner. Recalibrate the
scanner after replacing the glass.
Hook
Pin
Place the
hook on the
round pin
8-11
Lift the glass-plate up to free it.
Advertisement
Table of Contents
