Contex FLEX50i User Manual page 35

Configuration and Setup
Printer Model
> Custom Setup
The Printer Model - Custom Setup option lets you configure a printer manually. This option gives you
the freedom to use other printers than those compatible with the Auto Configure method and those
that have been tested and are available through the Printer List method.
Here follows a short description of the parameter settings. Use the arrow button up or down
to move through the options. Use Enter to activate the option's value selection. Use again the arrows
to change the option values and again the Enter button
Option Values
Command Set RTL or PCL3GUI
Ctrl. Language None or HP PJL
Orientation Landscape/Portrait
Scalable No/Yes
Resolution 300,360,600,720
A0,A1,A2....paper
Printer Size
size list
Default/No Simple/
Render Type
Ctx format
Use Inked Area No/Yes
Repeat steps 4 – 6 with B&W Printer. To reach the B&W Printer option from the previous step: Use
8.
the Back button
Back
reach the B&W Printer option.
Description
This is the printer's format language
The control language is used internally by the system to
apply some of the others settings, such as resolution, size,
etcetera.
Feeding orientation for printer. On most large format printers
this will be landscape while on some of the narrower models
it will be Portrait.
'No' means that the scanner will take care of scaling before
sending data to the printer.
'Yes" means that the printer will take care of scaling.
This is the printer's fixed resolution
The printer is defined to be of a certain max standard size -
A0, A2 etcetera.
Scan to print data protocol. See the lists fro right selection.
Yes – The printer will cut the output by looking at the area
that was actually printed.
No – use the whole paper size to determine the place to cut.
to move back to Color Printer in the menu and then arrow down
Enter
to confirm your setting.
3-23
to