Table of Contents
Advertisement
Maintenance
8.4 Running the Scanner Maintenance Program
The way you start and run the Scanner Maintenance Program depends on your scanner model and
configuration.
8.4.1 Starting Scanner Maintenance from a PC on the LAN
If the scanner is connected to the LAN, you must run the Scanner Maintenance program from a PC that
recognizes the scanner. This can be done from a PC on the LAN that has WIDEsystemNET setup to
recognize the scanner and the Scanner Maintenance program installed. The scanner must also be
enabled for sharing. See the sections
instructions. See your WIDEsystemNET on-line help for details on adding a scanner to the list of
recognized scanners on a PC.
To start scanner maintenance from a PC on the LAN:
1. Start WIDEsystemNET and select the scanner from your list of scanners.
2. Right-click on the WIDEsystemNET icon and select Scanner Maintenance.
3. Follow the Scanner Maintenance instructions described below.
8.4.2 Starting Scanner Maintenance from a Local PC
If the scanner is not enabled for network/shared scanning, you must run the Scanner Maintenance
program from a PC connected locally through the USB port. The PC must have WIDEsystemNET and
Scanner Maintenance installed. See the section:
Scanner to a PC
for information on setting up this type of configuration.
To start Scanner Maintenance from a local PC:
Right-click on the WIDEsystemNET icon and select Launch Scanner Maintenance.
1.
2.
Follow the Scanner Maintenance instructions described below.
"Scanner on Network
Setup" and
Scanner Configuration and Setup – Connect the
8-6
"Setup to Share the
Scanner" for
Advertisement
Table of Contents
