Singer Quantum XL-6000 Workbook page 39

3. To Edit a design element, place the cursor to the immediate right of the
design to be edited, as it appears in the display area of the upper screen.
This designated element will now be highlighted within the "hoop" area on
screen. Make desired changes and then touch the
return to the previous screen.
Note: This function can be used to select a given design to sew next.
MOVING THROUGH A DESIGN
This function may be used to restart embroidery from a position at which
thread has broken, or to move through a design to a selected area.
1. Stop the machine. Raise the needle and lift the presser foot.
2. Touch the
3. Should thread breakage occur, it is possible to move the needle and re-
stitch the area.
4. To change the needle position, touch
of the
will back up the needle position, in increments of 10 stitches. The plus (+)
is fixed and will always move the needle forward one (1) stitch at a time.
Note: The 10-stitch increment is a default setting, but can be
changed as desired, in the Options Screens (see instruction manual).
5. To select a portion of the design to sew:
•
Touch the
through the entire design element by percentage. To move forward
through the design, touch the (+) Pictogram. To move backward
through the design, touch the (-). The ratio of %-of-stitches is with
respect to the total number of stitches in the pattern.
•
To return the needle position to the beginning of the current
design, touch the
Pictogram.
Pictogram. Each touch of the minus (-) Pictogram
Pictogram. Move forward or backward
- 36 -
Quantum
Combination Embroidery
located to the left and right
Pictogram.
XL-6000
®
Pictogram to