Zoneplayer 100 Rear Panel Connectors - Sonos Multi-Room Music System User Manual

Chapter 2: System Setup

ZonePlayer 100 Rear Panel Connectors

Ethernet switch connectors (4)
Right speaker terminals
Left speaker terminals
Voltage select
AC power (mains) input
Analog audio out 
(fixed/variable)
Analog audio in
Subwoofer output
Note: If you disconnect your subwoofer, make sure
to also disconnect the subwoofer's cable from the
ZonePlayer output.
Use Category 5 Ethernet cable to connect to a router, computer, or additional network
device such as a network-attached storage (NAS) device.
LED indicators:
•
Green (link connection)
•
Flashing Yellow (network activity)
Use high-quality speaker wire to connect the right speaker to the ZonePlayer.
Use high-quality speaker wire to connect the left speaker to the ZonePlayer.
AC 115/230 V
Select the voltage setting that is appropriate for your country.
Use the supplied power cord to connect to power outlet.
Use a standard RCA audio cable to connect the ZonePlayer's analog audio outputs to
the audio inputs on a separate audio component, such as an amplifier or your home
theater receiver.
Use a standard RCA audio cable to connect the audio outputs from a separate audio
component such as a CD player, to the ZonePlayer's analog audio inputs.
Connect a powered subwoofer to this output using a standard RCA cable. The system
will detect when a cable is connected to the subwoofer output and adjust the crossover
frequency automatically.
2-25