F/W Upload Screen; Figure 214 Firmware Upload; Table 145 Firmware Upload - ZyXEL Communications ZyWall 35 User Manual

Internet security appliance

Hide thumbs Also See for ZyWall 35:

Table of Contents

ZyWALL 35 User's Guide

Table 144 Device Mode (Bridge Mode) (continued)

24.7 F/W Upload Screen

Find firmware at www.zyxel.com in a file that (usually) uses the system model name with a

"*.bin" extension, e.g., "zywall.bin". The upload process uses HTTP (Hypertext Transfer

Protocol) and may take up to two minutes. After a successful upload, the system will reboot.

the Uploading Firmware and Configuration Files section

FTP/TFTP commands.

Click MAINTENANCE, and then the F/W UPLOAD tab. Follow the instructions in this

screen to upload firmware to your ZyWALL.

The following table describes the labels in this screen.

Click Apply to save your changes back to the ZyWALL. After you click Apply,

please wait for one minute and use the IP address you configured in the LAN

Interface IP Address field to access the ZyWALL again.

Click Reset to begin configuring this screen afresh.

Type in the location of the file you want to upload in this field or click Browse ... to find it.

Click Browse... to find the .bin file you want to upload. Remember that you must

decompress compressed (.zip) files before you can upload them.

Click Upload to begin the upload process. This process may take up to two minutes.

Note: Do not turn off the ZyWALL while firmware upload is in

for upgrading firmware using

Chapter 24 Maintenance