Applying Policy To Packets; Figure 352 Menu 25.1.1: Ip Routing Policy Setup - ZyXEL Communications ZyWall 35 User Manual

Internet security appliance
Hide thumbs Also See for ZyWall 35:
Table of Contents

Advertisement

ZyWALL 35 User's Guide
Table 204 Menu 25.1: IP Routing Policy Setup
FIELD
port start / end
Destination
addr start / end
port start / end
Action
Gateway addr
Type of Service
Precedence
Log
Edit policy to
packets received
from
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or
[ESC] to cancel" to save your configuration or press [ESC] to cancel and go back to the previous
screen.

42.2.1 Applying Policy to Packets

To apply the policy to packets received on the selected interface(s), go to Menu 25.1: IP
Routing Policy Setup and press [SPACE BAR] to select Yes in the Edit policy to packets
received from field. Press [ENTER] to display Menu 25.1.1 - IP Routing Policy Setup
(shown next).

Figure 352 Menu 25.1.1: IP Routing Policy Setup

550
DESCRIPTION
Source port number range from start to end; applicable only for TCP/UDP.
Destination IP address range from start to end.
Destination port number range from start to end; applicable only for TCP/UDP.
Specifies whether action should be taken on criteria Matched or Not Matched.
Defines the outgoing gateway address. The gateway must be on the same subnet
as the ZYWALL if it is on the LAN, otherwise, the gateway must be the IP address
of a remote node. The default gateway is specified as 0.0.0.0.
Set the new TOS value of the outgoing packet. Prioritize incoming network traffic
by choosing Don't Care, Normal, Min Delay, Max Thruput, Max Reliable or Min
Cost.
Set the new outgoing packet precedence value. Values are 0 to 7 or Don't Care.
Press [SPACE BAR] and then [ENTER] to select Yes to make an entry in the
system log when a policy is executed.
Press [SPACE BAR] and then [ENTER] to select Yes or No (default). Select Yes to
configure Menu 25.1.1: IP Routing Policy Setup discussed next.
Menu 25.1.1 - IP Routing Policy Setup
Apply policy to packets received from:
LAN= No
DMZ= No
ALL WAN= Yes
Selected Remote Node index= N/A
Press ENTER to Confirm or ESC to Cancel:
Chapter 42 IP Policy Routing

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zywall 70

Table of Contents