Denso AT27Q-SB User Manual page 91

2d code handy scanner
Table of Contents

Advertisement

(8) Data transmission format common to all interfaces
Items
Transmission of code ID mark
Code ID mark position
Code ID mark
Code ID mark output mode
Transmission of the number of digits
(not applicable to UPC/EAN codes)
Prefix transmission
Suffix transmission
Scanner ID output
GTIN format conversion
Conversion type from UPC/EAN/
Interleaved 2of5 (14-digit) to GTIN format
Conversion type from GS1 DataBar
(RSS)/GS1-128 (EAN-128) in GTIN
format to EAN format
Prefix PI in conversion from UPC/EAN/
Interleaved 2of5 (14-digit) to GTIN format
(Note 1) No BCC will be transferred if no header is prefixed.
Parameters
Enable
Disable
Before prefix
After prefix
Type 1 (DENSO1)
Type 2 (DENSO2)
Type 3
Type 4
User-defined
Coupling
Separating
Enable, in 4 digits
Enable, in 2 digits
Disable
Enable
Disable
Enable
Disable
Enable
Disable
Enable
Disable
Conversion to 16 digits
Conversion to 14 digits
Conversion prohibited
Conversion to 14 digits
Conversion to 13 digits
Conversion prohibited
0 to 9
78
Defaults
0
: Can be changed only with the configuration software.
Refer to:
Section 8.3
Section 8.3
Section 8.3, (5)
Section 8.3, (5)
Section 8.3, (6)
Section 8.3, (2)
Section 8.3, (4)
Section 8.4
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

At27q

Table of Contents