Setup; Batteries - Fluke 1625-2 User Manual

Function
 flashes on display

Setup

Batteries

Rechargeable batteries may be used but must be charged outside of the
instrument. The number of measurements available with these cells will
typically be different to those available using alkaline cells.
This Tester is equipped with six 1.5 V batteries IEC LR6 type AA. Replace or recharge
the batteries if the battery indicator shows 1 or 0 bars.
To insert the batteries:
1. Switch off instrument, see Figure 2.
2. Disconnect all test leads.
3. Open battery compartment.
4. Insert batteries. Always replace the complete set of batteries.
5. Close battery compartment.
Table 5. Display Descriptions (cont.)
Displays
Hardware malfunction
(for example, current
overload).
edw049.eps
EE PROM memory
access malfunction.
edw050.eps
Internal computation
malfunction.
edw051.eps
Thermal overload.
edw052.eps
Note
Condition
Switch ON/OFF if still
faulty.
The symbol may
appear when using the
stakeless
measurement on low
resistance circuits.
Contact service.
Cool thoroughly.
Earth/Ground Tester
Setup
Note
13