Omron SYSDRIVE 3G3JV User Manual page 217

List of Parameters
Parame- Name
ter No.
(Register
No.
(Hex))
n01 Parameter Used to prohibit parameters to be written, sets
write-pro- parameters, or change the monitor range of
(0101)
hibit selec- parameters.
tion/
Used to initialize parameters to default values.
parameter
initializa- 0: Sets or monitors parameter n01. Parame-
tion
1: Sets or monitors parameters n01 through
6: Clears the error log.
8: Initializes parameters to default values in
9: Initializes parameters to default values in
n02 Operation Used to select the input method for the RUN
command and STOP commands in remote mode.
(0102)
selection
0: The RUN and STOP/RESET Keys on the
1: Multi-function inputs through the control cir-
2: Operation commands via RS-422A/485
Note
n03 Frequency Used to set the input method for the frequency
reference reference in remote mode.
(0103)
selection
0: Digital Operator
1: Frequency reference 1 (n21)
2: Frequency reference control circuit terminal
3: Frequency reference control circuit terminal
4: Frequency reference control circuit terminal
6: Frequency reference via RS-422A/485
n04 Interrup- Used to set the stopping method for use when
tion mode the STOP command is input.
(0104)
selection
0: Decelerates to stop in preset time.
1: Coasts to stop (with output shut off by the
n05 Reverse Used to select the operation with the reverse
rotation- command input.
(0105)
prohibit
0: Reverse enabled.
selection
1: Reverse disabled.
n06 STOP/RE- Used to select the stop method in remote
SET Key mode with n02 for operation mode selection
(0106)
function set to 1.
selection
0: STOP/RESET Key of the Digital Operator
1: STOP/RESET Key of the Digital Operator
10-2
Description
ters n02 through n79 can be monitored
only.
n79.
2-wire sequence.
3-wire sequence.
Digital Operator are enabled.
cuit terminals in 2- or 3-wire sequence.
communications are enabled.
The RUN command only through key
sequences on the Digital Operator is
acceptable in local mode.
(0 to 10 V)
(4 to 20 mA)
(0 to 20 mA)
communications
STOP command)
enabled.
disabled.
Setting Unit of Default
range setting setting
0, 1, 6, 8, 1 1
9
0 to 2 1 0
0 to 4, 6 1 0
0, 1 1 0
0, 1 1 0
0, 1 1 0
Chapter 10
Changes Refer-
during op- ence
eration page
No 5-2
No 5-7
No 5-8
No 5-17
No 5-16
No 5-7