Separation Of Gyro Pcb - Canon DC10 E Service Manual

1-8 Separation of GYRO PCB

(1) Remove one screw (a × 1), and detach the GYRO GND Plate.
(2) Remove two screws (a × 2), disconnect the CN1601, and detach the GYRO PCB Section.
(3) Remove two screws (a × 2), and detach the GYRO PCB.
(4) Detach the CCD Connector Sheet from the GYRO Holder.
<Note on Reassembling>
(1) Attach the CCD Connector Sheet as shown in the figure below.
(2) Attach the GYRO PCB Section as shown in the figure below.
Note on Reassembling (1)
GYRO Holder
Attachment
reference
Bend it and stick it so that the face
and the back have the same length.
GYRO GND Plate
(1) - a
(2) - a
a
2.5mm
Metal
M1.7
(3) - a
(3)
GYRO PCB
GYRO Holder
CCD Connecter Sheet
CCD
Connecter
Sheet
(2) - a
(1)
(2)
(2)
CN1601
GYRO PCB
Section
(4)
Fig. 12
Note on Reassembling (2)
GYRO Holder
Insert the CCD FPC
between the GYRO PCB
and the GYRO Holder.
15
DC10 E, DC20 E
DISASSEMBLING
GYRO PCB
CCD FPC