Canon DC10 E Service Manual page 102

<Note on Reassembling>
(1) Attach the LCD Sheet 1 to the position indicated in the figure below.
(2) Attach the parts ranging from the LCD Frame to the LCD PCB as shown in the figure below.
(3) Attach the LCD Sheet 2 to the position indicated in the figure below.
Note on Reassembling (2)
GND Spring section
LCD Frame
A
1. Push the LCD Panel into the GND Spring
section and then into the sections A and B.
LCD Back Light Ass'y
C
LCD Shield Sheet
3. With the four sections C aligned with the LCD
Back Light Ass'y, stick the LCD Shield Sheet.
Push into the hole.
5. Attach the LCD PCB.
Note on Reassembling (1)
LCD Bottom Cover
Attachment
reference :
−1 mm
Align with the end
of the angle R.
Wrinkle and slippage not allowed.
A
LCD Panel
Push in
B
Attachment
reference
C
LCD PCB
Adjust them.
Note on Reassembling (3)
Align with the sheet
metal of LCD Frame.
LCD Sheet 1
Attachment
reference :
−1 mm
Attachment
reference :
−2 mm
Attachment
reference :
−1 mm
Align with the step difference.
LCD Bottom Cover
2. Attach it to the LCD Bottom Cover.
LCD Frame
LCD Back Light Ass'y
4. Attach the LCD Back Light Ass'y.
Solder α
LCD BACK LIGHT FPC
6.Assemble the parts and solder (α) them.
LCD Sheet 2
Wrinkle and slippage not allowed.
Fig. 38
41
DC10 E, DC20 E
DISASSEMBLING
Make it hit against
the end.
Attachment
reference :
−1 mm
Attachment
reference :
−1 mm