Is Section Adjustment; Gyro Offset Adjustment - Canon DC10 E Service Manual

5-4 IS Section Adjustment

Note)
(1) Perform the IS adjustment after machine is re-assembled to a product status.
(2) Prepare a tripod or stable work bench.
(3) Each of the adjustment data (5-4-1) becomes valid when 5-4-2 data writing is made. After completion of each adjustment, be sure
to carry out 5-4-2 before turning power OFF.

5-4-1 Gyro Offset Adjustment

SPEC. Automatic adjustment
Procedure)
(1) Wait at least 10 seconds while being careful not to apply vibration to the camera.
(2) Referring to the table shown below, perform the automatic adjustment.
Note)
It will take approx. 25 seconds at maximum to complete adjustment (OK) after storing (pressing the pause button).
ST EP PROCEDURE
GYRO OFFSET
1 1) Make the setting shown at right.
2) Perform storing.
(press the PAUSE button.)
ST
MONIT OR
CS Function MD ADDR DT
2 08 ST 320D
RD
B7 B6 77 79
Fig. 18
25
SERVICE MODE / ADJUSTMENT
Microcomputer operation
ST
00
05 Adjustment is completed.
Completion with ST :05, NG with ST :09
After adjustment, data is indicated at IS3 and IS4.
B7 : Yaw Gyro gain
B6 : Pitch Gyro gain
77 : Yaw Gyro offset
79 : Pitch Gyro offset
DC10 E, DC20 E