Ccd Image Adjustment Result Check (Low Temperature) - Canon DC10 E Service Manual

5-2-7 CCD Image Adjustment Result Check (Low Temperature)

For this adjustment, use the same conditions as those specified in 5-2-2 Iris Adjustment (Coarse Adjustment)
SPEC. Automatic writing
Procedure)
(1) Check and write the result data of CCD image adjustment.
ST EP PROCEDURE
RESULT CHECK
1 1) Make the setting shown at right.
2) Perform storing.
(press the PAUSE button.)
2 1) Make the setting shown at right.
2) Perform storing.
(press the PAUSE button.)
3 1) Make the setting shown at right.
2) Perform storing.
(press the PAUSE button.)
Note)
If the result of any one of the above check steps is NG, carry out the adjustment procedures described in item 5-2 "CCD Section (1)"
again from the beginning while maintaining the internal camera temperature within the allowable range. If NG is indicated repeat-
edly, replace the CCD PCB with a new one.
STATUS
(ST)
Note)
For details of the error codes, refer to p.30.
MONIT OR
CS Function MD ADDR DT
2 08 ST 3017
RD
2 08 ST 3018
RD
2 08 ST 3019
RD
ERROR No. TOTAL CER
Fig. 16
21
SERVICE MODE / ADJUSTMENT
Microcomputer operation
-- Color difference check
Adjustment is completed.
Completion with ST :05, NG with ST :09
-- Noise check
Adjustment is completed.
Completion with ST :05, NG with ST :09
-- Check result writing
Adjustment is completed.
Completion with ST :05, NG with ST :09
NER
DC10 E, DC20 E