Replacing The Projection Lens - Kodak 2400 DV Plus User Manual

Replacing the
projection lens
A-61316 April 2010
To replace a lens with a magnification different from the pre-installed
lens:
1. Grasp the Prism Holder lever and push it up.
2. Pull out the lens unit.
3. Slide the lens unit into position along the lens guide.
4. Pull out the Brightness Select lever and slide it to a position
appropriate for the type of the projection lens loaded in the scanner.
The lever should click into position.
NOTE: Brightness on the screen may be uneven if the Brightness
Select lever is not placed in a position corresponding to the
type of the projection lens being used. Be sure to place the
lever into the correct position according to the type of
projection lens.
Type 1
Type 2 Type 3
3-3