Supero SUPERSERVER 6027R-TRF User Manual page 86

SUPERSERVER 6027R-TRF USER'S MANUAL
SERR# Generation
Select Enabled to allow a PCI device to generate a SERR number for a PCI Bus
Signal Error Event. The options are Enabled and Disabled.
Maximum Payload
This feature selects the setting for the PCIE maximum payload size. The options are
Auto, 128 Bytes, 256 Bytes, 512 Bytes, 1024 Bytes, 2048 Bytes, and 4096 Bytes.
Maximum Read Request
This feature selects the setting for the PCIE maximum Read Request size. The
options are Auto, 128 Bytes, 256 Bytes, 512 Bytes, 1024 Bytes, 2048 Bytes, and
4096 Bytes.
ASPM Support
This feature allows the user to set the Active State Power Management (ASPM)
level for a PCI-E device. Select Force L0 to force all PCI-E links to operate at L0
state. Select Auto to allow the system BIOS to automatically set the ASPM level for
the system. Select Disabled to disable ASPM support. The options are Disabled,
Auto, and Force L0s.
Onboard LAN Option ROM Select
This feature selects whether to load the iSCSI or PXE onboard LAN option ROM.
The options are iSCSI and PXE.
Load Onboard LAN1 Option ROM/Load Onboard LAN2 Option ROM
Select Enabled to enable the onboard LAN1 Option ROM~LAN4 Option ROM. This
is to boot the computer using a network device. The default setting for LAN1 Option
ROM is Enabled. the default setting for LAN2 Option ROM is Disabled.
VGA Priority
Use this feature to specify which graphics controller to be used as the primary boot
device. The options are Onboard and Offboard (VGA).
Network Stack
Select Enabled to enabel PXE (Preboot Execution Environment) or UEFI (Unifi ed
Extensible Firmware Interface) for network stack support. The options are Enabled
and Disabled.
7-16