Table of Contents
Advertisement
SUPERSERVER
NIC1 (LAN1) LED
The LED connections for LAN1 are on
pins 11 and 12 of JF1. Attach LAN LED
cables to display network activity. See
the table on the right for pin defi nitions.
HDD LED
The HDD LED connection is located
on pins 13 and 14 of JF1. Attach the
hard drive LED cable here to display
disk activity (for any hard drives on the
system, including SAS, Serial ATA and
IDE). See the table on the right for pin
defi nitions
Power On LED
The Power On LED connector is
located on pins 15 and 16 of JF1. This
connection is used to provide LED
indication of power being supplied to
the system. See the table on the right
for pin defi nitions.
NMI Button
The non-maskable interrupt button
header is located on pins 19 and 20 of
JF1. Refer to the table on the right for
pin defi nitions.
Serial Ports
Two COM connections (COM1/COM2)
are located on the motherboard. COM1
is located on the Backplane I/O panel.
COM2, located close to PCI-E Slot1,
provides front access support. See the
table on the right for pin defi nitions.
6027R-TRF USER'S MANUAL
Pin Defi nitions
Pin# Defi nition
11
12
Pin Defi nitions
Pin# Defi nition
13
14
Power LED
Pin Defi nitions
Pin# Defi nition
15
16
NMI Button
Pin Defi nitions
Pin# Defi nition
19
20
Serial Port Pin Defi nitions
(COM1/COM2)
Pin # Defi nition
1
DCD
2
RXD
3
TXD
4
DTR
5
Ground
(NC = No connection)
5-18
NIC1 LED
(JF1)
Vcc
Ground
HDD LED
(JF1)
Vcc
HD Active
(JF1)
5V Stby
Control
(JF1)
Control
Ground
Pin # Defi nition
6
DSR
7
RTS
8
CTS
9
RI
10
NC
Advertisement
Table of Contents
