Other Features
Other onboard features that promote system health include onboard voltage
monitors, auto-switching voltage regulators, chassis and CPU overheat sensors,
power management, AC power loss recovery, virus protection and BIOS rescue.
1-3
Server Chassis Features
The 6027R-TRF is built upon the SC825TS-R740LPBP chassis. Details on the
chassis and on servicing procedures can be found in Chapter 6. The following is a
general outline of the main features of the chassis.
System Power
The SC825TS-R740LPBP features a redundant 740 Watt power supply consisting
of two power modules. The system does not need to be shut down when replacing
or removing a single power supply module.
Hard Drive Subsystem
The SC825TS-R740LPBP chassis was designed to support eight hot-swap SATA
or SAS hard drives.
Note: A SAS UIO card must be installed to support SAS drives - not included
with system.
PCI Expansion Slots
A riser card (RSC-R2UU-UA3E8+) on the left side of the chassis can support a
AOC-PG-i2+ add-on card to provide two additional Gb LAN ports. Alternately, this
slot can instead support either a UIO card, one PCI-E x16 card, or four SAS/SATA
drives with an optional UIO SAS card. See our web site for details (http://www.
supermicro.com/products/nfo/UIO.cfm). See section 5-6 for further details.)
Front Control Panel
The control panel on the SUPERSERVER 6027R-TRF provides you with system
monitoring and control. LEDs indicate system power, HDD activity, network activity,
system overheat and power supply failure. A main power button and a system reset
button are also included. In addition, two USB ports have been incorporated into
the control panel to provide front side USB access.
1-3
Chapter 1: Introduction