Supero SUPERSERVER 6027R-TRF User Manual page 57

Watch Dog Enable/Disable
Watch Dog (JWD) is a system monitor
that will reboot the system when a
software application hangs. Close Pins
1-2 to reset the system if an application
hangs. Close Pins 2-3 to generate a
non-maskable interrupt signal for the
application that hangs. See the table
on the right for jumper settings. Watch
Dog must also be enabled in the BIOS.
VGA Enable/Disable
Jumper JPG1 allows the user to enable
the onboard VGA connector. The default
setting is 1-2 to enable the connection.
See the table on the right for jumper
settings.
BMC Enable
Jumper JPB1 allows you to enable
the embedded WPCM 450 BMC
(Baseboard Management) Controller to
provide IPMI 2.0/KVM support on the
motherboard. See the table on the right
for jumper settings.
Manufacturer Mode Select
Close this jumper (JPME1) to bypass
SPI fl ash security and force the system
to use the Manufacturer mode which
will allow the user to fl ash the system
fi rmware from a host server to modify
system settings. See the table on the
right for jumper settings.
Write_Protect Enable
Close pins 1/2 of Jumper JWP1 to
enable Write_Protect support for system
security and data integrity. See the table
on the right for jumper settings.
Chapter 5: Advanced Serverboard Setup
Watch Dog Enable/Disable
Jumper Settings (JWD)
Jumper Setting
Pins 1-2
Pins 2-3
Open
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Pins 1-2
Pins 2-3
BMC Enable/Disable
Jumper Settings (JPB1)
Jumper Setting
Pins 1-2
Pins 2-3
ME Mode Select Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Write_Protect Enable/Disable
Jumper Settings (JWP1)
Jumper Setting
Pins 1-2
Pins 2-3
5-25
Defi nition
Reset
NMI
Disabled
Defi nition
Enabled
Disabled
Defi nition
BMC Enable (Default)
Disabled
(JPME1)
Defi nition
Normal (Default)
Manufacture Mode
Defi nition
Normal (Default)
Write_Protect Enabled