Adjusting Projected Images
d
Select the corner to correct using the [
buttons on the remote control, or the [
buttons on the control panel, and then press the [
], [
], [ ], and [ ]
], [
], [Wide], and [Tele]
w
v
] button.
e
Correct the position of the corner using the [
[ ] buttons on the remote control, or the [
and [Tele] buttons on the control panel.
When you press the [
] button, the screen shown in step 4 is
displayed.
If the message "Cannot adjust any further." is displayed while
adjusting, you cannot adjust the shape any further in the direction
indicated by the gray triangle.
f
Repeat procedures 4 and 5 as needed to adjust any remaining
corners.
g
When you are done, press the [Esc] button to exit the correction
menu.
Because Keystone was changed to Quick Corner, the corner
selection screen shown in step 4 is displayed the next time you press
the [
] or [
] buttons on the control panel. Change Keystone to
w
v
53
], [
], [ ], and
], [
], [Wide],
w
v