Table of Contents
Advertisement
Loading the Firmware to the Switcher
To load a new version of firmware to the switcher using Firmware Loader, connect your
computer serial port to the switcher 9-pin RS-232 connector (non-audio SW2 and SW4
DVI Plus) or to the first three pins of the switcher Remote/Auto-SW serial port (all other
models). (See
connecting to the serial port.)
1.
If you have not already done so, download and install the Firmware Loader executable
installer file to your computer (see
on the previous page).
2.
If necessary, download the latest SW DVI Plus firmware version and install it on your
computer (see
3.
Open the Firmware Loader via your desktop
Start
Loader
The Firmware Loader window opens with the Add Device window displayed in front.
4.
On the Add Device window, select your SW DVI Plus model from the
drop-down menu (
or
SW8 DVI Plus Series
5.
From the
Figure 27.
6.
From the
appropriate port configuration parameters (obtained from your system administrator).
Figure 28.
"Wiring for RS-232
Control" in the "Installation" section for information on
"Downloading the SW DVI Plus
>
All Programs
>
Extron Electronics
SW2 DVI Plus Series
).
drop-down menu, select
Connection Method
Connection Method Menu on the Add Device Window
Com Port
and
Baud Rate
RS-232 Drop-down Menus on Add Device Window
SW DVI Plus Series • Remote Configuration and Control
"Downloading and Installing Firmware
Firmware" on the previous page).
menu by selecting the following:
Start
>
Firmware Loader
,
SW4 DVI Plus Series
RS-232
drop-down menus that appear, select the
Loader"
>
Firmware
Device Names
,
SW6 DVI Plus Series
(the only option).
27
27
27
Advertisement
Table of Contents
