Extron electronics SW2 DVI A Plus User Manual page 38

Extron sw dvi plus series
Table of Contents

Advertisement

Audio output
Number/signal type ........................ 1 stereo, balanced/unbalanced
Connectors .................................... (1) 3.5 mm captive screw connector, 5-pole
Impedance ..................................... 50 ohms unbalanced, 100 ohms balanced
Maximum level (Hi-Z) ...................... >+16.5 dBu, balanced; >8.2 dBV, unbalanced at 1% THD+N
Maximum level (600 ohm) .............. >+10.4 dBm, balanced; >7.1 dBm, unbalanced at 1% THD+N
Control/remote — switcher
Serial control port
SW2 and SW4 DVI Plus ............ 1 RS-232 9-pin female D
All other models ...................... 1 RS-232 3.5 mm captive screw connector, 5-pole (shared with auto-input
Baud rate and protocol ................... 9600 baud, 8 data bits, 1 stop bit, no parity
Serial control pin configurations
SW2 and SW4 DVI Plus ............ 2 = Tx, 3 = Rx, 5 = GND
All other models ...................... 1 = Tx, 2 = Rx, 3 = GND
Contact closure .............................. SW6 and SW8 DVI Plus models; and SW2, SW4, SW6, and SW8 DVI A Plus only:
Contact closure pin configuration ... SW6 and SW8 DVI Plus models; and SW2, SW4, SW6, and SW8 DVI A Plus only:
IR controller module ....................... IR 102 Remote Control, optional
Program control ............................. Extron Universal Switcher Control/configuration program for Windows
General
Power supply .................................. External
Power consumption
SW2 and SW4 DVI Plus
Device ................................ 2.6 watts, 12 VDC
Device and power supply ... 5.3 watts, 12 VDC
SW2 and SW4 DVI A Plus
Device ................................ 3.5 watts, 12 VDC
Device and power supply ... 4.5 watts, 12 VDC
SW6 and SW8 models
Device ................................ 7.7 watts, 12 VDC
Device and power supply ... 10 watts, 12 VDC
Temperature/humidity .................... Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Cooling .......................................... Convection, no vents
Thermal dissipation
SW2 and SW4 DVI Plus
Device ................................ 9.2 BTU/hr
Device and power supply ... 18.1 BTU/hr
SW2 and SW4 DVI A Plus
Device ................................ 11.6 BTU/hr
Device and power supply ... 15.0 BTU/hr
SW6 and SW8 models
Device ................................ 27.1 BTU/hr
Device and power supply ... 34.1 BTU/hr
switching control)
For auto-input switching only. (1) 3.5 mm captive screw connector, 5 pole (shared
with RS-232)
4 and 5 shorted together enable auto-input switching mode.
30' maximum, 40 degrees off axis
Extron Simple Instruction Set (SIS
Input: 100-240 VAC, 50-60 Hz
Output: 12 VDC, 1 A
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
SW DVI Plus Series • Reference Information
)
®
32
32
32
32

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sw4 dvi a plusSw6 dvi a plusSw8 dvi a plus

Table of Contents