Table of Contents
Advertisement
Error Responses
If the switcher is unable to execute a command it receives because the command is invalid
or contains invalid parameters, the switcher returns an error response to the host. Error
response codes and their descriptions are as follows:
E01 – Invalid input channel number (out of range)
E06 – Invalid input selection during auto-input switching
E10 – Invalid command
E13 – Invalid value (out of range)
Using the Command and Response Table
The
Command and Response Table for SIS
valid ASCII and hexadecimal command codes, the switcher responses to the host, and a
description of the command function or the results of executing the command.
The ASCII to Hex Conversion Table below is for use with the command and response table.
Space
Figure 20.
Symbol Definitions
]
= CR/LF (carriage return/line feed) (hex 0D 0A)
}
= Soft carriage return (no line feed)
•
= Space
E
= Escape key
X!
= Input number
X@
= On/off and signal status
X#
= Firmware version (to two decimal places)
X$
= Switch mode
X%
= EDID mode/file selection
X^
= Current EDID information in hexadecimal
X&
= Native resolution and refresh rate (translated from the EDID)
NOTE:
ASCII to Hex Conversion Table
ASCII to Hex Conversion Table
0 through the maximum number of inputs on the unit
0 = deselect all inputs
0 = Off/signal not present
1 = On/signal present
1 = normal switch mode
2 = auto-input switch mode
0 = automatic mode (no EDID file selected)
1-15 = factory-loaded EDID file number (For a description of available EDID files, see the
EDID Minder
commands on page 21.)
16 = User-assigned (EDID for the current display)
Unless otherwise indicated, commands are not case sensitive.
SW DVI Plus Series • Remote Configuration and Control
Commands, starting on the next page, lists
•
19
19
19
Advertisement
Table of Contents
