Table of Contents
Advertisement
1U Universal Rack Shelf
Front false
faceplate
uses 2
screws.
Use 2 mounting holes on
opposite corners.
Figure 34.
Mounting an SW DVI Plus Two-input or Four-input Switcher on a
Standard 9.5-inch Deep Rack Shelf
Back of the rack mounting
The SW2 DVI Plus and the SW4 DVI Plus can also be mounted vertically to the front
or rear rack supports, using the optional MBB 100 Back of the Rack Mounting Kit
(part number 70-367-01) as follows:
1.
If rubber feet were previously attached to the bottom of the unit, remove them.
2.
Remove the two screws from each side of the switcher. Retain the screws for possible
later reassembly.
3.
Attach the brackets to the sides of the unit, using the longer screws included in the
mounting kit.
Figure 35.
Attaching the Back of the Rack Mounting Brackets
4.
Mount the switcher to the rack support, using the two included rack screws.
1/2 Rack Width Front False
Faceplate
(2) 4-40 x 3/16"
Screws
SW DVI Plus Series • Reference Information
36
36
36
36
Advertisement
Table of Contents
