Internal Microphone - Toshiba QOSMIO F30 Series Maintenance Manual

4 Replacement Procedures

4.19 Internal microphone

Removing the Internal microphone
The following describes the procedure for removing the internal microphone (See Figure 4-
31).
1. Peel off the glass tape.
2. Disconnect the microphone cable from the connector CN6050 on the jack board and
remove the internal microphone from the microphone holder.
Installing the Internal microphone
The following describes the procedure for installing the internal microphone (See Figure 4-
31).
1. Connect the microphone cable to the connector CN6050 on the jack board and
install the internal microphone into the microphone holder.
NOTE: Install the internal microphone while inserting the slot into the guide.
2. Arrange the microphone cable in place and stick the glass tape.
4-50 [CONFIDENTIAL]
Microphone cable
Figure 4-31 Removing the internal microphone

4.19 Internal microphone

Glass tape
Internal microphone
CN6050
QOSMIO F30 Maintenance Manual (960-555)
Slot
Guide
Microphone
holder