Switching The Machine Off With The Infrared Control Device - MULTIQUIP RX 1510-C Operation Manual

Start-up
5.4.3
The transmitter is ready for use as long as the toggle switch "Start-Stop" is in the
switch position "Neutral".
► Always turn the transmitter off by switching the toggle switch to "Stop" during

Switching the machine off with the infrared control device

► Move the toggle switch "Start-Stop" on the infrared control from the switch
position "Neutral" to the right to switch position "Stop".
breaks and after finishing work.
► The following code is displayed: „F I 4100". The LEDS for generator and oil
pressure drop are active. The stop procedure is initiated.
Stop procedure
► Code „F I 4200" is displayed, if no further signal is received from the generator
and from the oil pressure sensor.
CAUTION
F I 4 I00
F I 4200
– 72 –
RX 1510-C/-I/-CI