Table of Contents
Advertisement
RX 1510-C/-I/-CI
5.3
Starting the machine
5.3.1
Code S. - -05
The machine only reacts to the control mode with which your engine was started.
The machine only reacts to control impulses of the manual control, if the engine
has been started with the manual control. The machine only reacts to control
impulses of the infrared control, if the engine has been started with the infrared
control. An exception is starting and shutting down the machine. This is also
always possible with the ignition key. The first used control mode has priority, if
the machine has been started at the cockpit with the ignition key.
Switching ignition on
The display elements are tested after switching the ignition on. The number of
888888 as well as the warning lights illustrated here light up. The cockpit should
be exchanged, if a number is not complete. Troubleshooting is necessary, if one
of the warning lights does not light up. If the cause is a defective warning light,
this only affects machine safety in as far as a defect will not be indicated by the
machine controller and therefore not immediately recognised by the operator.
1
Display test
Code S is displayed after about 1 second. - - 05 and the operating hour meter
alternating on the display. The machine can now be started from the ignition lock,
manual control, or infrared control.
S .--05
– 65 –
888888
Operating hour meter
Start-up
0.0
Hide quick links:
Advertisement
Table of Contents
