Operation Program Summary; Startup And Initial Screen - Toa NX-100 Installation Setup Manual

1. NX-100 OPERATION PROGRAM SUMMARY
This operation program is used to set the control buttons used for broadcasts, and activate set NX-100 and
NX-100S broadcast patterns*
* The broadcast pattern is determined by the combination of the contents of the sound source and the units
1
targeted to receive the broadcast. One target unit can be set for unicast streaming, and up to 64 units for
multicast streaming. Only one pattern can be set per button.
Note
For more information concerning broadcast pattern settings, refer to
* The NX-100's and NX-100S' contact output is controlled via the network. Up to 64 units x 8 channels can
2
be controlled per button.

2. STARTUP AND INITIAL SCREEN

Either double-click on the Operation program icon created on the desktop at the time of program installation or
double-click on the application [nx100_control.jar] installed in the software folder. The following initial window
(with nothing set in it) will then be displayed.
Group buttons
The 10 Group buttons and 50 Selection buttons are displayed, with each button being numbered before any
button setting is performed.
Chapter 5: OPERATION SETTINGS (NX-100 OPERATION PROGRAM)
1 or operate the contact output* 2 .
Chapters 3
Selection buttons
and 4.
5-2