Contact Input Setting - Toa NX-100 Installation Setup Manual

6.1. Contact Input Setting

Set the broadcast pattern to be started, and the contact bridge. When the contact input is selected, the screen
will switch over to the contact input setting screen. Select [Enable] and set the contact input contents.
(1) Operation Mode
Select from [Momentary] and [Latch]. Operations are as follows:
Momentary: The designated broadcast pattern or other unit's contact is activated while the input is ON.
The start mode stops when the input is OFF.
Latch: When the input is turned on, the designated broadcast pattern or other unit's contact is
activated, and the start mode continues even if the input is turned OFF. The start mode stops
when the input is turned ON again.
• Momentary
Make
Contact input
Break
Contact input
Broadcast and
contact data
• Latch
Make
Contact input
Break
Contact input
Broadcast and
contact data
(2) Polarity
Set to either [Make] or [Break].
Make: ON when contact is closed.
Break: ON when contact is opened.
Chapter 4: SYSTEM SETTINGS (SETTING USING BROWSER)
ON
ON
Activation
ON
50 ms or more
50 ms or more
ON
Activation
Stop
ON
ON
Stop
ON
ON
ON
ON
4-14