Nomenclature And Functions [Front] - Toa NX-100 Installation Setup Manual

3. NOMENCLATURE AND FUNCTIONS
[Front]
• NX-100
NETWORK AUDIO ADAPTER NX-100
LNK/ACT
1
• NX-100S
NETWORK AUDIO ADAPTER NX-100S
LNK/ACT
1
1. LNK/ACT Indicator (Green)
Lights when the unit is connected to a network.
Flashes while the unit is transmitting or receiving
data.
2. FD/COL Indicator (Yellow)
Remains lit while the network is in full-duplex
communications mode.
Flashes whenever data collision is detected.
3. Input Signal Indicator (Green)
Lights when the audio signal applied to the Audio
input terminal (19) is adjusted to a level enough
high for transmission to a network with the Input
volume control (20).
4. Input Peak Indicator (Red)
Remains lit while the input audio signal is being
distorted.
Set the Input volume control (20) and the Input
level selection switch (21) to a proper position
according to the input signal level.
FD/COL
2
FD/COL SIGNAL
2
NX-100S only
NX-100S only
Chapter 1: BEFORE INSTALLATIONS AND SETTINGS
5 6
STATUS
5 6
INPUT
PEAK STATUS
3 4
5. Status Indicator (Yellow)
Remains lit during broadcasts.
Flashes while the unit is writing data into the
internal storage medium (flash memory).
6. Error Indicator (Red)
Lights if an error is detected during transmission,
etc.
7. Run Indicator (Green)
Remains lit during normal operation.
Flashes at 2-second intervals when a failure is
detected.
8. Reset Button
Restarts the unit when pressed.
9. MAC Address
The unit's MAC address consists of 12 hyphenated
alphanumeric characters.
7
ERROR RUN
RESET
00-05-F9-FF-80-81
9
7
ERROR RUN
RESET
00-05-F9-FF-80-81
9
8
8
1-3