Installation Folder Configuration; Uninstalling Each Software - Toa NX-100 Installation Setup Manual

5.4.3. Installation folder configuration

The installed software program is stored by default in C:\Program Files\TOA\NX-100. The installation folder is
configured as follows. (However, the unit setting file is only created after having been set by the setup
program, and the unit operation log is created after the NX-100/100S unit's first actual operation.)
Installation Folder
nx100_control.jar (Operation Program)
nx100_util.jar (Setup Program - Installation Setting)
packet_audio.jar
data (data folder)
Config (folder to store unit setting files)
Log (folder to store logs)
System.nxc (setup program system file)
panel.nxc (operation program system file)
Data in the data folder are commonly used by both the Setup Program and the Operation Program. The Setup
Program and the Operation Program always operate based on the unit setting files in the data folder.
Manually opening or saving these files cannot be performed.
Do not change the configuration or name of the file or folder in the installation folder.
When creating other systems or saving backup copies, copy the data folder into other location and save it. (To
reuse, replace the data folder with the one in use.)

5.5. Uninstalling Each Software

Select [Control Panel] → [Add/Remove Programs] to delete.
Chapter 2: UNIT AND SOFTWARE INSTALLATIONS
[IP address].cfg (unit setting file)
[IP address].log (unit operation log file)
2-15